The whole quality inspection process of injector valve set includes:

1. Inspect raw materials and make backup of raw materials test report;

2. Cutting raw materials with blanking machine;

3. Inspect raw material's cutting diameter and length;

4. Forging and forming processing on the raw materials;

5. Inspectors conduct the all kinds of inspections of forming blank;

6. Remove the blank scrap ;

7. Blast the surface of the blank;

8. Conduct surface treatment inspection after sandblasting;

9. Perform blank machining;

10. Process valve set body seal threading;

11. Process Valve body connection threading;

12. Process valve set's hole;

13. Inspector conducts general inspection;

14. Install the injector valve assembly;

15. The packing workshop finish product packaging.

Before sending out of the factory, the finished valve sets still need to undergone through three inspections—full inspection, random inspection, and batch inspection, different brands of test benches are used to test the same valve set for a total of no less than three times.

Apart from above, injector valve assembly is one of the most important running parts, it is also one of parts with the highest damage rate, even tiny particles ( under 50 μm) can cause failure of valve set and even entire components. So it is important to make sure the whole produce process and installation and its working place are dust-free.